Hello
In order to create covers for 3'' floppy disks, I am looking for any information, like the dimensions of a regular cover (Amsoft style) or, even better, any templates you may have been using (Photoshop, Illustrator, etc).
cheers,
Froggy
Label and layout
Re: Label and layout
My 3" label for Blake's 7 was made by hand on Publisher, and is 70x70mm and with a spine of 5mm
For 3.5 disks there are templates available (Avery templates are quite famous) and they can be installed on Publisher directly through the template configuration options.
For 3.5 disks there are templates available (Avery templates are quite famous) and they can be installed on Publisher directly through the template configuration options.
Re: Label and layout
that's the label for the floppy itself. I am looking for the one for the case, the one printed with the graphic cove that you fold (not glue) into the case.
Re: Label and layout
Ah, ok. Sorry I misunderstood.
Just measured one: height is something such as 104 mm, and width 84mm, with a spine of aprox 6mm in width, and the short side that comes after the spine is around 16mm, leaving aprox 67mm for the back side.
Not sure if I made myself understandable
Just measured one: height is something such as 104 mm, and width 84mm, with a spine of aprox 6mm in width, and the short side that comes after the spine is around 16mm, leaving aprox 67mm for the back side.
Not sure if I made myself understandable
Re: Label and layout
Hope that helps:
Re: Label and layout
Thanks to you Chema & Dbug